Technical Support for the Primatech Q550 Pneumatic Nailer

Available documents:

IMPORTANT NOTE !

The finely threaded components of the engine powering this tool do not require the use of threadlocker or sealant. The cylinder should always be hand-screwed onto the head/valve assembly before inserting the whole assembly into tool main body. Tighten with moderate force and lock in place with the head lock.

NEVER apply threadlocker or sealant onto cylinder or head threads. The use of a threadlocker will VOID the warranty.
Use RUBBER end

Never STEEL end

CAUTION !

The Q550 Pneumatic Nailer is designed to be operated with a 2.5 lbs mallet. Use only the rubber end of the mallet to actuate the tool. The use of the steel end will damage the head assembly and will VOID the warranty.

 
This tool requires minimal lubrication. Use only detergent-free oil such as Primatech P-090. Few drops of oil weekly in the air inlet is sufficient. Other types of lubricant may degrade the seals.

Piston ring is a wear part that should last over 1,000,000 cycles (about 200,000 sq.ft.) under normal use. Dirt or particles in the compressed air may lessen its life.

It is recommended to replace this part if the tool needs to be opened for servicing and has been in use for some time.

© Copyright 2006-2009 Primatech. All right reserved. Disclaimer. Comments to webmaster.